Configuring The Signal Modules - Siemens SIMATIC PCS 7 Configuration

3 Configuring the redundant peripherals

3.3 Configuring the signal modules

Activity
7. Enter the address in the dialog box
"PROFIBUS IM 153-2 Interface Properties"
and click "OK".
The connection to the redundant
PROFIBUS DP stream is automatically
established.
3.3 Configuring the signal modules
The following section explains the procedure for configuring the standard and
HART signal modules.
Note For the time being do not add any HART field devices to the HART signal
modules. This sequence will be explained in chapter 3.7.
Requirements
The PCS 7 project with an H CPU has been created and is open in SIMATIC
Manager.
A redundant PROFIBUS-DP master system is configured for the SIMATIC
H station in HW ConFigure
In HW Config, the interface module IM 153-2 is configured for the ET 200M
at the redundant PROFIBUS DP.
Configuration of Redundant I/O Modules
Entry-ID: 28430682, V2.0, 03/2015
Screenshot
42