4: Connecting The Ac Power Cord - Sony STR-DA2100ES Operating Instructions for STRDA2100ES Operating Instructions Manual

Tip
To connect certain speakers to another power
amplifier, use the PRE OUT jacks. The same signal is
output from both the SPEAKER jacks and the PRE
OUT jacks (front speakers only).
Speaker impedance
(Front speakers only)
To enjoy the best possible multi channel
surround, connect speakers with a nominal
impedance of 8 ohms or higher to the FRONT,
CENTER, SURROUND and SURROUND
BACK terminals, and set the IMPEDANCE
SELECTOR to "8Ω". Use the screwdriver to set
the impedance selector to the correct position.
Refer to the operating instructions supplied with
your speakers if you are not sure of their
impedance. (This information is often on the
back of the speaker.)
Alternatively, you may connect speakers with
nominal impedances between 4 and 8 ohms to
any or all of the speaker terminals. However, be
sure to set the IMPEDANCE SELECTOR to
"4Ω" if you connect even one speaker with
nominal impedance between 4 and 8 ohms.
Note
Be sure to turn the power off before adjusting the
IMPEDANCE SELECTOR.
4: Connecting the AC
power cord
Connect the supplied AC power cord to the AC
IN terminal on the receiver, then connect the AC
power cord to a wall outlet.
FRONT A
R L
– – +
R L
FRONT B
AKERS
SURROUND
R L
– – +
R L
URROUND BACK (2ND ZONE)
AC OUTLET
Notes
• The AC OUTLET(s) on the rear of the receiver is a
switched outlet, which supplies power to the
connected component only while the receiver is
turned on.
• Make sure that the total power consumption of the
component(s) connected to the receiver's AC
OUTLET(s) does not exceed the wattage stated on
the rear panel. Do not connect high-wattage
electrical home appliances such as electric irons,
fans, or TVs to this outlet. This may cause a
malfunction.
AC power cord
AC IN terminal
SWITCHED 120W/1A MAX
AC 120V 60Hz
AC OUTLET
continued
17 US