Sony STR-DA2100ES Operating Instructions for STRDA2100ES Operating Instructions Manual page 11

2 Connect the video jacks.
The following illustration shows how to connect a DVD player with COMPONENT VIDEO (Y,
P /C /B-Y, P /C /R-Y) output jacks. Connecting a TV with component video input jacks allows you
B B R R
to enjoy higher quality video.
DIGITAL
OPTICAL
TV/SAT
IN
MD/
TAPE
IN
MD/
TAPE
OUT
SA-CD/
CD
IN
DVD
IN
SA-CD/
CD
IN
COAXIAL
ASSIGNABLE
(INPUT ONLY)
Tips
• When using the S-video jacks instead of the video jacks, your monitor must also be connected via an S-video jack.
S-video signals are on a separate bus from the video signals and will not be output through the video jacks.
• On this receiver, standard video signals can be converted to component video or S-video signals and S-video
signals can be converted to component video signals. These upconverted video signals can only be output from the
MONITOR VIDEO OUT jack. However, you cannot convert the component video signals to standard video or
S-video signals.
• When standard video signals (composite video signals) or S-video signals from a VCR etc. are converted upward
on this receiver and then output to your TV, depending on the status of the video signal output, the image on the
TV screen may appear distorted horizontally or no image may be output.
DVD player
OUTPUT
OUTPUT OUTPUT
VIDEO S VIDEO COMPONENT
P /C /R–Y P /C /B–Y Y
R R B B
C D H
ANTENNA
S-VIDEO S-VIDEO
IN IN
AM
VIDEO IN VIDEO IN VIDEO OUT
L
R
AUDIO IN AUDIO IN AUDIO OUT
TV/SAT DVD VIDEO 2
SIGNAL GND
L L L
R
R R
IN IN OUT IN FRONT SURROUND
PHONO SA-CD/CD MD/TAPE MULTI CH IN
TV monitor
INPUT INPUT
VIDEO S VIDEO
C D
Y
P /C
B B
S-VIDEO S-VIDEO S-VIDEO
/B-Y
OUT IN OUT
P /C
R R
/R-Y
TV/SAT
VIDEO IN VIDEO OUT VIDEO IN VIDEO OUT
IN
ASSIGNABLE
L L
MONITOR COMPONENT VIDEO
R R
IR
AUDIO IN AUDIO OUT AUDIO IN
TRIGGER OUT
VIDEO 1 IR REMOTE
OUT
L
L
CENTER 4Ω 8Ω
R
R
SURR SUB SUB
IMPEDANCE
OUT
BACK WOOFER WOOFER
SELECTOR
2ND ZONE PRE OUT
INPUT
COMPONENT
P /C /R–Y P /C /B–Y Y
R R B B
H
DVD MONITOR
IN OUT
IR
IN
RS232C
+ –
CENTER
SPE
11 US