Table of Contents
Advertisement
Step 3: Connecting the AC
power cord
Connect the AC power cord of the receiver to
the power outlet.
Initial setup
Before using the receiver for the first time,
initialise the receiver by performing the
following procedure.
This procedure can also be used to return the
settings that you have made to their defaults.
1
Press the ?/1 button on the receiver to
turn it off.
2
Hold down the ?/1 button for 5
seconds.
The following items are reset or cleared
when INITIAL appears on the display:
• All the sound field parameters are reset to
their defaults.
• All SET UP, LEVEL, and TONE
parameters are reset to their defaults.
• The sound fields memorised for each
programme source and preset stations are
cleared.
• The master volume is set to VOL MIN.
GB
18
AC power cord
To power outlet
Step 4: Inserting batteries
into the remote
Insert two R6 (size AA) batteries with the + and
– properly oriented in the battery compartment.
Tip
Under normal conditions, the batteries should last
about six months. When the remote no longer operates
the control centre, replace both batteries with new
ones.
Notes
• Do not leave the remote in an extremely hot or humid
place.
• Do not use a new battery with an old one.
• Do not expose the remote sensor of the control centre
to direct sunlight or lighting equipment. Doing so
may cause malfunctions.
• If you do not use the remote for an extended period
of time, remove the batteries to avoid possible
damage from battery leakage and corrosion.
• Turn off the power to all components before making
any connections.
• Be sure to make connections firmly to avoid hum and
noise.
Advertisement
Table of Contents
