Single Width Airway Module, E-Minic; Multiparameter Hemodynamic Modules - GE Datex-Ohmeda S/5 Technical Reference Manual

5.3.7 Single width Airway Module, E-miniC

Wait until the message 'Calibrating gas sensor' disappears from the screen.
1. Block the tip of the sampling line with your finger and check that the message 'Sample
line blocked' appears on the monitor screen within 30 seconds.
2. Detach the Mini D-fend and check that the message 'Check D-fend' appears on the
monitor screen within 30 seconds.
Breathe to the sampling line briefly. Check that the CO2 information is updated on the
screen.

5.3.8 Multiparameter Hemodynamic Modules

ECG and RESP measurements
1. Connect an ECG cable to the module. Connect the cable leads to a patient simulator.
Check that all ECG and impedance respiration information is shown on the monitor
screen as configured on the simulator.
Turn the simulator off. Check that the 'Asystole' message appears on the screen.
Temperature measurement
2. Check the temperature channels with a patient simulator.
Check that temperature measurement information is shown on the monitor screen as
configured on the simulator.
Invasive blood pressure measurement
3. Check the function of the front panel membrane keys.
4. Check the InvBP channels with a patient simulator.
Zero the InvBP channels and check that the values and waveforms correspond to the
simulator settings.
SpO2 measurement
5. Connect an SpO2 finger probe to the module. Check that the message 'Probe off' is shown
when the probe is not connected to a finger.
6. Attach the SpO2 probe to your finger. Check that a reading of 95-99 and a pleth
waveform appear on the screen
Non invasive blood pressure measurement
7. Check the function of the front panel membrane keys.
8. Attach an adult NIBP cuff onto your arm and check that the module identifies the cuff, i.e.
the text 'Adult' appears in the NIBP digit field for a short time.
Functional check
Document no. M1137263-04
69