Resolution Selection For Optional B-Dispx; Resolution Selection For Primary Display; S/5 Remote Controller, K-Remco; Figure 18 Resolution Dip Switch Settings, B-Dispx - GE Datex-Ohmeda S/5 Technical Reference Manual

Figure 18

3.6.2 Resolution selection for optional B-DISPX

The resolution selection dip switch positions are presented in
settings, B-DISPX. If the AUTO mode is selected, the resolution can be set by monitor software.
In other modes, the resolution is set accordingly.

3.6.3 Resolution selection for primary display

The resolution selection for primary display is set through the monitor software setting only.

3.7 S/5 Remote Controller, K-REMCO

Connection to Central Unit
Connect the Remote Controller cable to the X11 connector on the CPU board, B-CPU6. Tighten
the finger screws.
S3 S2
Resolution dip switch settings, B-DISPX
Resolution settings are
made by dip switch S3
S3 switches
sw1 sw2
Auto off off
VGA off on
SVGA on off
XGA on on
Figure 18 Resolution dip switch
Document no. M1137263-04
System installation
39