Instructions For Plasma Cutter; Specifications - Elettro CF Plasma 484 Instructions Manual

IMPORTANT
READ THIS MANUAL AND THE SAFETY RULES
MANUAL CAREFULLY BEFORE INSTALLING, USING,
OR SERVICING THE MACHINE, PAYING SPECIAL
ATTENTION TO SAFETY RULES. CONTACT YOUR
DISTRIBUTOR IF YOU DO NOT FULLY UNDERSTAND
THESE INSTRUCTIONS.
This machine must be used for cutting only.
It is also essential to pay special attention to the "SAFETY
RULES" Manual. The symbols next to certain paragraphs
indicate points requiring extra attention, practical advice or
simple information.
This MANUAL and the "SAFETY RULES" MANUAL must
be stored carefully in a pica familiar to everyone involved in
using the machine. They must be consulted whenever
doubts arise and be kept for the entire lifespan of the
machine; they will also be used for ordering replacement
parts.
1 GENERAL DESCRIPTION

1.1 SPECIFICATIONS

This manual has been prepared for the purpose of
educating personnel assigned to install, operate and
service this machine.
This cutting power source, developed with inverter
technology, comes equipped with a built-in compressor that
supplies the torch with the air required to work.
Upon receiving the machine, make sure there are no
broken or damaged parts.
The purchaser should address any complaints for losses or
damage to the vector. Please indicate the article and serial
number whenever requesting information about this
machine.
1.2 DESCRIPTION OF DEVICES ON THE MACHINE
A) Mains power LED.
B) Block LED; lights when hazardous conditions
arise.
C) Thermostat LED.
D) Low air pressure LED.
E) Grounding clamp.
F) Torch.
G) Power cord.
H) Mains power switch.
1.3 SAFETY DEVICES
This system comes equipped with the following safety
devices:
Overload cut-out:
To avoid overloads. It is evidenced by the C led
continuously on (see pict.1).
Pneumatic:
Located on the torch inlet to prevent low air
pressure. The LED D lights when tripped (see
pict.1).

INSTRUCTIONS FOR PLASMA CUTTER

1.4 EXPLANATION OF TECHNICAL SPECIFICATIONS
IEC 60974-1 The equipment is built according to these
IEC 60974-7 standards.
IEC 60974-10
Cl. A Machine for professional and industrial use.
Single-phase
frequency converter.
Down slope.
Suitable for plasma cutting.
TORCH TYPE Type of torch to be used with this machine
to form a safe system.
U0 Secondary open-circuit voltage.
X Duty cycle percentage.
The duty cycle expresses the percentage of
10 minutes during which the cutting
machine may run at a certain current I
voltage U
I Cutting current.
2
U Secondary
2
welding current I
on the distance between the contact tip and
the workpiece.
If this distance increases, the cutting
voltage also increases and the duty cycle
X% may decrease.
U Rated supply voltage.
1
1~ 50/60Hz 50- or 60-Hz single-phase power supply
I Max Max.
1
corresponding current I
I eff This is the maximum value of the actual
1
current absorbed, considering the duty
cycle.
IP23 Protection rating for the housing.
Grade 3 as the second digit means that this
equipment is suitable for use outdoors in
the rain.
Suitable for use in high-risk environments.
NOTES: The machine has also been designed for use in
environments with a pollution rating of 3. (See IEC 664).
6
static transformer-rectifier
without overheating.
2
conventional voltage
. This voltage depends
2
absorbed current
and voltage U
2
2
and
2
with
at the
2