Bt12 Control Module Installation - Carefree FREESTYLE EVOLUTION Installation Manual

Carefree of Colorado
BT12 C
ONTROL
(Refer to the wiring diagram on page 11.)
NOTICE
Do not mount the unit near heat producing elements such as LP appliances or engine
exhaust components.
NOTICE
For best reception, do not mount the unit near or on a metal surface.
1. Clean the mounting surface. The surface must be flat and
clean for the mounting tape to properly adhere.
2. Remove the release paper from the tape on the back of the
module and firmly press the module onto the mounting
surface.
NOTE: The module may be oriented for best fit with
access to the wire leads.
3. Attach the motor wires (refer to diagram for corresponding
wire colors) to the module leads for the motor using 14-
16awg butt splices.
4. Run a minimum 14 awg wire to chassis ground.
Suitable ground would be the vehicle chassis or
conductive structure connected to the chassis. Splice
the wire to the module GND lead with a 14-16awg butt splice.
5. Run a minimum 14 awg wire from the power distribution panel (auxiliary battery circuit) or equivalent. The
circuit should be protected by a 15-amp fuse. Splice the wire to the module +12V lead with a 14-16awg
butt splice.
NOTE: If the wire run is 30 feet or longer for +12Vdc and/or GND, use 12awg wire to prevent voltage
drop. Use the appropriate butt splices for the wire size.
6. Splice the Black wire from the LED Harness to the module LED GND lead (Black) with a 18-22awg butt splice.
7. Route the module LED + lead (RED) to the awning lights switch location. Use 20awg wire and 18-22awg butt
splice to extend the lead as necessary.
8. Route the module IGN LOCK lead (Green) to the vehicle PCM or other switch source (used for ignition lockout).
9. Route the remaining wires (Violet, Gray, Yellow and Brown) to the location for the awning control switches. Use
20awg wires and 18-22awg butt splices to extend the leads as necessary.
070036-001r1
Installation Manual
M I
ODULE NSTALLATION
F
REESTYLE
Mounting
Tape
Remove
Release Paper
E A
VOLUTION WNING
BT003
9