Table of Contents
Advertisement
E
CLIPSE
E
LECTRICAL
WARNING
working on or around the electrical system.
Notes:
1. Failure to follow the wiring instructions in this publication may void the motor warranty.
2. D
wire two or more motors to one switch—No parallel wiring.
O NOT
3. All wiring must conform to NEC (National Electrical Code) and local codes.
4. OEM's may choose to furnish the control switch. The switch must be a DC polarity reversing
switch with dynamic brake.
The standard Eclipse Patio Awning comes with a single switch. The single switch configuration has one interior
extend/retract switch. The Eclipse is also available with the optional Direct Response auto retract system
S
S
I
INGLE
WITCH
1. Determine the final location of the switch and mark the
location.
2. Drill a 5/16" hole through the vehicle wall for the motor
cable.
3. Route the cable through the holes to the location of the
switch panel.
4. Seal the cable and hole using a silicone sealant.
5. At the switch location, cut a rectangular hole 1.25"(3.2cm)
x 1.88" (4.8cm) through the mounting surface.
#6 x 3/4 Screw
(2 plcs)
2 . 8 8 "
[ 7 . 3 c m
( r e f )
1 . 8 8 "
[ 4 . 8 c m
]
( r e f )
6. Determine the switch orientation:
6.1. The wires of the connector extend from the side of the switch with 3 terminals on the back.
6.2. For wire routing on the right side of the switch as shown in Details A and B, orient the switch with
the 3 terminals on the right.
6.3. For wire routing on the left side of the switch as shown in Detail C, orient the switch with the 3
terminals on the left.
6.4. Push the switch into the faceplate until the tabs on the switch "click" into place behind the
faceplate. Ensure that the switch and faceplate are oriented so that the lettering is up and the
wires are oriented as desired.
6.5. Set switch aside.
1
Direct Response is available as a factory installed option for OEM's. For aftermarket installations, the Direct
Response system is available as an upgrade kit SR0036.
8
Installation Manual
Shock Hazard. Always disconnect battery or power source before
NSTALLATION
1 . 2 5 "
[ 3 . 2 c m
]
1 . 8 8 "
[ 4 . 8 c m
]
]
1.25"
Min. Clearance
[3.2cm]
From Mounting Face to
Rear of Switch Connector
5/16" Hole
Thru Existing
Slot
Top of Channel Routing
Bottom of Channel Routing
Left Side Orientaion
SK002d
Carefree of Colorado
Motor Cable
5/16" Hole
1 1/2"
Motor Cable
SK002a
052568-001r5
1
.
E0005
Advertisement
Table of Contents
