INTRODUCTION
General instructions
•
Installation must be performed by experienced and knowledgeable technicians.
•
Consult your supervisor if problems occur during installation.
•
Do not apply excessive force or pressure on components during installation.
Electricity
•
AC controller only: Ensure that a suitable electrical power supply is available in the vicinity of the
installation for electrical connection of the controller (see Electricity connection, page 5).
•
An additional electrical socket should be available at the installation site for installation and service.
Components and structure
A media filtration system is comprised of the following components:
Inlet
Backwash outlet
Backwash manifold
Media filter tank
Outlet manifold
Location of the tank ports
1
Filling port
2
Side service port
3
Bottom service port
2
4 | SANDSTORM
SINGLE/DOUBLE CHAMBER INSTALLATION MANUAL
™
Backwash 3-way hydraulic valves
3
Inlet manifold
Grooved coupling
1
2
Air valve
Filtration system
control kit
Outlet
Manifold
support legs