Using The Watch In A Medical Facility Or Aircraft; Using Mobile Link With A Mobile Phone; Getting Ready; A Install The Required App On Your Phone - Casio 5596 Operation Manual

Using the Watch in a Medical
Facility or Aircraft
Whenever you are in a hospital, on an aircraft,
or in any other location where auto time
calibration signal receive or connection with a
phone may cause problems, you can perform
the procedure below to disable such
operations. To re-enable auto time
adjustment, perform the same operation
again.
1.
Press (A).
The second hand will indicate the last
receive result for nine or ten seconds.
30
2.
Within 10 seconds after you perform the
operation in step 1, pull out the crown to
the first click.
If more than 10 seconds elapse before
●
you pull out the crown after you perform
the operation in step 1, the second hand
will return to indicating seconds. If this
happens, perform step 1 again.
3.
Rotate the crown to disable auto time
adjustment.
[Y(YES)]: Auto time adjustment enabled.
[N(NO)]: Auto time adjustment disabled.
30
4.
Push the crown back in.
Note
If the watch is paired with a phone,
●
OCEANUS Connected can be used to
disable auto time adjustment.
Using OCEANUS Connected to
l
Disable Auto Time Adjustment
Operation Guide 5596
Using Mobile Link with
a Mobile Phone
While there is a Bluetooth connection
between the watch and phone, the watch time
setting is adjusted automatically. You can also
change the watch's other settings.
Note
This function is available only while
●
OCEANUS Connected is running on
the phone.
This section describes watch and
●
phone operations.
X : Watch operation
Y : Phone operation

Getting Ready

A Install the required app on your
phone.
In Google Play or the App Store, search for the
CASIO "OCEANUS Connected" app and
install it on your phone.

B Configure Bluetooth settings.

Enable the phone's Bluetooth.
Note
For details about setting procedures,
●
see your phone documentation.

C Pair the watch with a phone.

Before you can use the watch in combination
with a phone, you first need to pair them.
Crown
1.
Move the phone to be paired with close to
(within one meter of) the watch.
2.
Y On the Home Screen, tap the
"OCEANUS Connected" icon.
3.
Y Perform the operation shown on the
phone screen to be paired with.
If a pairing prompt message appears,
●
perform the operation shown on the
phone screen.
If pairing fails for some reason, perform
●
the procedure again from step 1.

Auto Time Adjustment

Your watch will connect with a phone at preset
times each day and adjust its time settings
automatically.
Using Auto Adjust
●
Your watch adjusts its time setting four times
a day according to a preset schedule. It
performs the adjustment operation
automatically as you go about your daily life,
without any operation required by you.
Important!
The watch may not be able to perform
●
auto time adjustment under the
conditions described below.
While the watch is too far away from
ー
its paired phone
While communication is not possible
ー
due to radio interference, etc.
While the phone is updating its
ー
system
If OCEANUS Connected is not
ー
running on the phone.
Note
If the watch does not indicate the
●
correct time even if it is able to connect
with a phone, adjust the hand and day
indicator positions.
Adjusting Hand and Day Indicator
l
Alignment
The watch will connect with the phone
●
and perform auto time adjustment at
around 12:30 a.m., 6:30 a.m., 12:30
p.m. and 6:30 p.m. The connection is
automatically terminated after auto
time adjustment is complete.
8