Milwaukee 5339-20 Repair Instructions page 22

REPAIR
INSTRUCTIONS
1
Installing the Install O-Ring (3) into opening of gear box
lever cover (4).
2
Squeeze together spring (6) at bottom
side of lever and insert it sideways into
opening of gear box cover (4), beginning
at the two lugs (7).
3
Set the lever (1) to 0.
4
Install spring clip onto adjusting plate (5),
then onto pin (2) of lever (1). See illustra-
tion below.
5
Set lever (1) to the "chisel" setting
1
Installing the Install gasket (3) into the gear box (4).
top gear box cov- Mind the right position!
er
Gasket (3) is in accordance with the
gear box pre-formed and fits the
groove of the gear box (4) exactly!
2
Install gear box cover (2): adjusting plate
(6) must lock into place in the groove of
the set collar (5) (see dotted line).
3
Install six screws with washers (1) into the
gear box cover (2) and tighten (torque =
4.5 Nm / 40 in. lbs.).
The six screws must be tightened
according to indicated numbers (1–7)
in ascending sequence! Push cover (2)
slightly in direction of arrow!
.
Adjusting
plate
Spring clip
3
3
6
7
Adjusting
plate
2
3
6
4
5
PAGE
22
58-92-5305 d1
1
2
3
4
5
Spring
clip
1