TSC TTP 244M Pro Series Quick Installation Manual

Printer Overview
Graphic LCD with Backlit
Display (Option)
Label Dispense
Opening
Liner
Opening
Note: The interface picture here is for reference only. Please refer to the specification for the interfaces
availability.
Ribbon Supply
Spindle
Label Roll
Guard
Label Supply
Spindle
Ribbon Rewind
Spindle
Print Head
Release Lever
Sensor Switch
Setting up the Printer
1. Connect the printer to the computer with the provided printer cable.
2. Plug one end of the power cord into the power connector at the rear of the printer, and then plug the other
end into a properly grounded wall outlet.
Note: Please switch OFF printer power switch prior to plug in to the power cord to printer power jack.
Quick Installation Guide
Centronics
USB Interface
Interface
(Option)
Ethernet
Interface
(Option)
Power Switch
Power Jack
Socket
Printer Cover
Print Head
Platen Roller
Front Panel
Media Sensor
Loading the Ribbon
Label Insert Opening
(For use with external
labels)
RS-232C
Interface
(1) Open the printer cover and front
SD Card Socket
panel.
(4) Insert the left side first. Install a
ribbon on the ribbon supply
spindle. Mount the
spindle on the rear hubs.
Adjustable
(7) Following the direction of the
Label Guide
 RIBBON label, pull the
transparent ribbon leader to the
front from under the ribbon
mechanism.
Page of 2 1
(2) Place an empty paper core onto
the ribbon rewind spindle.
(5) Please be noted that the bigger
hub side with 4 ribs must be
ribbon supply installed toward the right side of
ribbon mechanism.
(8) Attach the ribbon leader to the
empty paper core on the ribbon
rewind spindle (with a tape).
(3) Insert the left side first. Mount
the ribbon rewind paper core on
the front hubs. Please be noted
that the bigger hub side with 4
ribs must be installed toward the
right side of ribbon mechanism.
(6) Disengage the printer carriage
by pulling the print head release
lever.
(9) Rotate the ribbon rewind spindle
until the ribbon overlaps the
ribbon leader and stretches
tight.