Troubleshooting Guide; After Sales Service; Declaration Of Conformity Ce - Whirlpool AKP808 Series User Manual

10. TROUBLESHOOTING GUIDE

The burner does not light
• Is the gas supply tap open?
• Is there an interruption in the supply of gas?
• Is the cylinder empty?
• Are the burner openings obstructed?
The burner does not remain lit:
• Light it again with the knob turned to
the symbol representing the maximum
temperature.
Electric ignition is not working:
• Is there a power failure?

11. AFTER SALES SERVICE

Before contacting After Sales Service:
1.
Try to solve the problem (see
"Troubleshooting Guide").
2.
Turn off the appliance and restart it to see
if the fault is repeated.
If after the above checks the fault still
occurs, get in touch with the nearest After
Sales Service.
Please give:
• a short description of the fault,
• the exact type and model,
• the service number (number after the word
"SERVICE" on the rating plate) located on
the right front edge of the oven (visible
when the oven door is open). The service
number is also indicated on the guarantee
booklet,
• your complete address and phone number.
Repairs made under the guarantee
always require the intervention of the
Manufacturer's authorised service
centres, as shown in the guarantee
conditions.
In the event you need an intervention
by technicians not belonging to a
manufacturer authorised service centre,
make sure you are given a receipt showing
the work performed and make sure
that the replacement parts used were
manufacturer's original parts.
USER'S INSTRUCTIONS
22
Following these simple rules will guarantee
the product's quality and safety.

12. DECLARATION OF CONFORMITY CE

• This oven is intended to come into contact
with food products and conforms with
European Regulation 1935/2004 EC.
• This oven has only been designed for use
as a cooking device. Any other use (such
as heating rooms) is to be considered
improper and, as a consequence,
dangerous.
• This oven (Class 3) has been designed, built
and sold in compliance with:
- the safety requirements of "Gas" Directive
90/396/EEC;
- the safety requirements of "Low Voltage"
Directive 2006/95/EC;
- The protection
Directive 2004/108/EC.
- The requirement of Directive 93/68/EEC.
requirements of EMC