Instructions For The Installer; Installing The Appliance; Electrical Connection; Positioning The Oven - Whirlpool AKP808 Series User Manual

3. INSTALLING THE APPLIANCE

Installation must be carried out by a qualified
engineer in compliance with the relevant
regulations.

3.1 Electrical connection

The nameplate must never be removed.
The appliance must be connected to earth
in compliance with electrical system safety
regulations.
If a permanent connection is used, the
appliance's power supply line must be fitted
with an omni polar breaking device with
contact gap of at least 3 mm, located in an
easily accessible position close to the appliance
itself.
If a socket and plug connection is used, check
that they are of the same type. Do not use
reducers, adapters or junctions since they may
cause overheating or burns.
Operation at 220-240 V~: use a type H05RR-F
three-wire cable (Cable of 3 x 1.5 mm²).
The earth wire (yellow-green) must be at least
20 mm longer than the other wires at the end
for connection to the appliance.
The manufacturer declines all responsibility
for injury or damage caused by failure to
comply with the above regulations or deriving
from tampering with even just one part of the
appliance.

INSTRUCTIONS FOR THE INSTALLER

1.5 mm
2
brown
blue
yellow/green
20 mm

3.2 Positioning the oven

Only a qualified person in compliance
with the instructions provided install the
appliance. The manufacturer declines all
responsibility for improper installation, which
may harm persons and animals and damage
property.
Important: - The power supply to the appliance
must be cut off before any adjustments or
maintenance work is done on it;
- Air duct is supposed to use in ventilation.
Installation of Built-in Ovens
In order to ensure that the built-in appliance
functions properly, the cabinet containing it
must be appropriate.
The appliance is designed for built-in
installation (class 3) in cabinets of any heat-
resistant material. Comply with the dimensions
shown in figures 1, 2 and 3. when installing
under worktops, comply with the dimensions
shown in figure 1-3. when installing under
worktops incorporating hobs, a gap of at least
110 mm must be left from any side wall, as
shown in figure 1. when installing in tall units,
comply with the dimensions shown in figure
1-2 , bearing in mind that the top/rear of the
unit must have an opening 45mm deep. Screw
the 4 screws A into the inside of the frame (fig.1).
For installation under tops, make sure that the
rear/bottom of the unit has an opening similar
to that shown in figure 1 (B),and that the front/
bottom of the unit has an opening an aperture
of at least 45×560mm similar to that shown in
11