Room Ventilation; Combustion Gas Discharge - Whirlpool AKP808 Series User Manual

figure 1-3. Make sure that aperture similar to
the one in the window shade area is at least of
45×560mm (A). See the instructions supplied
with the hob for the relative positioning and
fixing procedures.
In compliance with current safety standards,
contact with the electrical parts of the oven
must not be possible once it has been installed.
All parts, which ensure the safe operation of the
appliance, must be removable only with the aid
of a tool.
Never use the door for leverage when inserting
the oven in the cabinet. Never apply excessive
pressure to the open door.
The panels of the adjacent cabinets must be
made of heat-resistant material. In particular,
cabinets with a veneer exterior must be
assembled with glues which can withstand
temperatures of up to 100°C.
measurements given in mm
INSTRUCTIONS FOR THE INSTALLER

3.3 Room ventilation

The appliance may only be installed in a
permanently ventilated room as specified by
the relevant regulations. The air flow into the
room where the appliance is installed must
be sufficient for proper gas combustion and
room ventilation. The air intakes, protected by
gratings, must be of suitable size (see relevant
regulations) and located so that they cannot be
even partially obstructed. The kitchen must be
kept properly ventilated to disperse the heat
and humidity produced by cooking processes:
in particular, a window should be opened or
the speed of any fans increased after prolonged
use.

3.4 Combustion gas discharge

Combustion gases must be discharged by
means of hoods connected to a flue with
reliable natural draught, or a fan extraction
system. An effective extraction system requires
careful design by an authorized specialist, and
must comply with the regulation distances and
positions. After installation, the engineer must
issue a certificate of compliance.
12