Start-Up; Setting Up - Parkside PHD 135 A1 Translation Of The Original Instructions

• If the power cable for this
equipment is damaged, it
must be replaced by the
manufacturer, a customer ser-
vice agent of the same or a
similarly qualified person in
order to prevent hazards.
• Do not pull the plug from the
socket by the cable. Protect
the cable from heat, oil and
sharp edges.
• Do not carry or fix the equip-
ment by the cable.
• Use only extension cables
that are protected from spray
water and designed for out-
door use. Always fully unroll
a cable drum before use.
Check the cable for damage.
• Before any work on the
equipment, during work
breaks and in the case of
non-use, remove the plug
from the socket.
• The cross-section of the pow-
er supply cable must not be
less than 2 x 2,5 mm².
• Wear sturdy footwear to pro-
tect against electric shock.
• To protect against electric
shock, operate the equipment
only in an upright position.

Start-up

In keeping with current regulations a
pressure cleaner must never be oper-
ated off the drinking water mains
supply without a controllable back-
flow preventer. A suitable backflow
preventer in conformity with
EN 12729 type BA must be used.
Water that has passed through a backflow
preventer is classified as undrinkable.
A backflow preventer is available in spe-
cialist shops.
A system separator (check valve) prevents
the backflow of water and detergent into
the drinking water pipeline.
• Employ an ordinary garden hose for
the water intake and ensure sufficient
length.
• Use the device on a domestic water
connection with an output of at least
450 l/h.
• Irrespective of the water pipe, you can
also use the device (for example, rain
barrel) through the integrated water
suction function. This function must only
be used with a suction hose with a fil-
ter basket.
The device itself must not be immer-
sed in open water sources. There
is a risk of personal injury from an
electric shock.
Do not draw in any water from na-
tural accumulations. There is a risk
of contamination from backwashed
cleaning agent.

Setting up

1. Fold the curved handle (1) up as far as
it will go.
2. Connect the high-pressure fitting (jet
gun) (23) to the jet gun (9). Ensure that
the hose runs to the front, so as not to
impede the handle (1).
3. Connect the feed hose to the water
supply and allow water to escape from
the other end of the feed hose with no
bubbles, in order to expel the air from
the feed hose. Switch off the water tap.
4. Connect the feed hose with the water
connection coupling (6) and the water
connection (7) on the device.
5. Connect to the spray gun (9) by insert-
ing and screwing in the jet pipe (15).
6. If the jet pipe (15) is mounted, connect
either the turbo dirt mill (22) or the
GB IE NI
9