Interrupting Operation; Ending Operation; Using Detergents; Cleaning And Maintenance - Parkside PHD 135 A1 Translation Of The Original Instructions

2. Switch off the water tap.
3. Connect the supply hose to the water
connection on the equipment using
the quick connector for garden hose
adapter.
4. Fully open the water tap.
To vent the equipment:
5. Switch on the on/off switch (3) until
pressure has built up.
6. Switch off the on/off switch (3).
7. Press the on lever on the gun (9) until
the pressure has gone.
8. Please repeat process 5. to 7. a few
times until there is no more air in the
device.
• You can lock the engaging lever
B
(13) of the spray gun (9) by fold-
ing out of the locking lever (14).
Lock the starting lever (13) to
prevent the pressure cleaner
from being inadvertently / ac-
cidentally started.

Interrupting operation

• Release the lever of the gun (13).
• During prolonged work intervals turn
off the pressure cleaner by its ON /
OFF switch (3).
If the equipment falls over,
switch off the equipment
immediately at the on/off
switch (3) and disconnect the
equipment from the mains at
the mains power cord.
of electric shock!
should the equipment be re-
turned to an upright position.
For your own safety, wait
approx. 5 minutes before re-
connecting to the electricity.
1. After having worked with a detergent
2. Release the lever of the gun (9).
3. Turn off the pressure by its ON / OFF
4. Turn off the water tap.
5. Disconnect the pressure cleaner from
6. Pull the lever of the gun (9) to vent the

Using detergents

The pressure cleaner was designed for
operation with a neutral detergent based
on a biologically decomposable anionic
tenside. Other detergents or chemical sub-
stances could impair the safety of the pres-
sure cleaner and damage it. Such damage
to the equipment is not covered by the
guarantee.
Cleaning and
Maintenance
Risk
Only now
GB

Ending operation

rinse the pressure cleaner with clear
water.
switch (3). Disconnect the mains plug.
the water mains.
pressure existing within the system.
Pull out the power plug before eve-
ry maintenance operation. This also
includes connecting to the water
supply or trying to eliminate leaks.
There is a risk of electrocution or of
injury from moving parts.

Cleaning

Never direct the water jet
against the pressure cleaner,
nor clean the pressure clean-
er under flowing water. This
could give rise to the danger
of electric shock and damage
the pressure cleaner!
IE NI
11