Operating The Chainsaw; Switching On; Checking The Chain Brake - FLORABEST FKS 2200 G4 Translation Of The Original Instructions

C
up with chain oil.
2. Wipe off any spilled oil and
close the cap (2) again.
Always switch off the device
and allow the motor to cool
before filling with chain oil.
There is a risk of fire if oil
overflows.

Operating the chainsaw

Switch on the chainsaw only when
chain bar, saw chain and sprocket
chain wheel covering are correctly
assembled. Ensure the voltage of the
mains connection agrees with the
label on the device. Make sure you
have a secure stance. Make sure be-
fore you start that the electric chain
saw is not touching anything.
Caution! Saw can oil up, see notes
on "Assembly - Mounting the saw
chain and blade"

Switching on

1. Check before the start, whether suf-
D
(see Chapter Operation Startup).
2. Connect the device to the mains
voltage.
3. Release the chain brake, where
you shift the brake arm (3) back
against the front grip (16).
4
with both hands, with the right
hand on the rear grip (1) and
the left hand on the front handle
close securely over the handles.
2

Checking the chain brake

E
G B I E
5. For switching on, activate the
switch-on block (14) with the right
thumb and then press the On/Off
switch (13), the electric power saw
runs with highest speed. Release
the switch-on block (14) again.
6. The power saw switches off when
you release the On/Off switch
(13) again. Switching for continu-
ous running is not possible.
The motor cannot be turned on if the
chain brake has engaged. Do not
employ the chain brake in order to
start the chainsaw or to switch it off.
1. Place the electric chainsaw onto
contact any objects.
2. Connect the device to the mains
voltage.
3. Release the chain brake by
shifting the brake arm (3) over
against the front grip (16).
4
with both hands, with the right
hand on the rear handle (1) and
the left hand on the front handle
close securely over the handles.
5. Turn on the electric chainsaw.
6. Activate the chain braking lever
(3), with running motor, with
the left hand. To do so, push the
chain braking lever/front hand
protection (3) away from the front
handle (16). Chain should stop
abruptly.
7. Once the chain brake is work-
ing properly, release the on/off
switch and the chain brake.
N I CY
1 7