Installing The Mlan16E2 - Yamaha Motif XS Series Service Manual

MOTIF XS6/MOTIF XS7/MOTIF XS8
mLAN16E2
The optionally available mLAN expansion board
(mLAN16E2) can be installed to the MOTIF XS6 and
MOTIF XS7. The MOTIF XS8 is equipped with two mLAN
connectors equivalent to the mLAN16E2 by default.

Installing the mLAN16E2

1
Turn the power of the MOTIF XS off, and
disconnect the AC power cord. Also, make
sure to disconnect the MOTIF XS from any
connected external devices.
2
Remove the cover for the mLAN16E2 from
the rear panel.
With the rear panel of this synthesizer facing you,
remove the two screws from the cover.
Important
Keep the removed screws in a safe place. They will be
used when installing the mLAN16E2. Be careful not to
misplace them. Keep the cover and fi xing screws in a
safe place for future use.
3
Insert the mLAN16E2 along the guide rails.
Push the mLAN16E2 all the way into the slot so
that the connector at the end of the mLAN16E2 is
correctly inserted into the connector inside the slot.
Guide rails
56
4
Replace the cover with the two screws you
removed in step 2 above.
CAUTION
Malfunctions or incorrect operation may occur if the
mLAN16E2 is not properly fastened.