Adding A Reset Input (Hand Push Mode) Into The Iris Radio Receiver - EMS SYSTEM 7000 Series Installation And Programming Instructions

EMS SYSTEM 7000
16. Adding A Reset Input (Hand push Mode) Into The IRIS Radio
Receiver
The following sequence of operations is required when adding an input, which is required
to reset the IRIS receiver. The inputs mode setting must be programmed as a hand push
and the input must be programmed into the UHF IRIS Radio Receiver as an Interrogator
transmitter. It should be noted that the IRIS receiver must have installed 7202
Interrogator software for this function to operate.
16.1 With the control keyswitch in
the "CLEAR" position the screen
should now display:
16.2 Turn the control keyswitch to
the
screen will now display:
16.3 Press the "0" key, and the
screen will display:
16.4 Enter the engineering default
PIN: "221100" and press the
"" button, and the screen will
now display:
16.5 Press the "" button until the
screen displays:
16.6 Press the "1" button and the
screen will display:
16.7 Press the "1" button and the
screen will display:
16.8 Press the "" button until the
screen displays:
©2015 EMS Security Group Ltd. All rights reserved.
"RESET" position.
System Clear
01/10/93
The
*** SYSTEM RESET ***
Enter Your PIN
For Menus > _
=Done =Del 13:26
|** Main Menu **|
> Pins & Access <
| System Support |
2=Help
| Time and Date |
> Radio Setup <
| Output Setup
2 = Help
| ** Radio Setup ** |
> Add Transmitter <
|
2 = Help
| -Add Transmitter-|
> Add Hand push <
| Add Moneyclip |
2 = Help
| Add Contact Txer |
> Add Interrogator <
| Add P-Call Txer |
2 = Help
25
13:26
13:26
13:27
|
16: 37
Txer Details |
16:37
16:37
16:37
TSD248 Iss 2 25/06/15 AJM