Con - EMS SYSTEM 7000 Series Installation And Programming Instructions

EMS SYSTEM 7000
6. ID
6.1 Each of the transmitters inputs have their individual identification numbers set from
this menu. This allows the input to be added into the IRIS receiver with a unique
number. The identification numbers are defaulted to range from A0001 - A0008 for
inputs 1-8. Under normal circumstances this menu should not require changing.
6.2 The only time the default settings will require changing is if additional transmitter
units have been added to an existing installation. If this is the case a print out
should be taken from the IRIS Receiver and the transmitter ID settings checked.
The new transmitter can then be added to the system ensuring that the new inputs
id's do NOT correspond with any already programmed into the IRIS unit.
6.3 To change the inputs identification number, from the command menu type id and
press the enter key. The display will then show:
Input No: 1
ID code (hex) is A0001
Change Y/N?
To change the ID press Y and then the enter key, the display will now show:
New ID Code (hex)
Enter the new ID code and press enter. If the hex number is a valid number the
display will change to show:
New ID Code (hex) NNNNN (Where N represents new code)
NNNNN
Input No: 2
ID code (hex) is
Change Y/N?
Repeat for all inputs if changes are required. If all changes are complete press the
enter key until the display returns to:
COMMAND id, con, type, mode
Txd, quit >

7. CON

7.1 Each of the transmitters inputs can be programmed to operate via a normally open
connection or normally closed configuration. The default setting for all of the inputs
is to normally open. If this requires changing, from the command menu type con
and press the enter key. The display will then show:
Input Number 1 is N/O
Change Y/N
©2015 EMS Security Group Ltd. All rights reserved.
15
TSD248 Iss 2 25/06/15 AJM