EMS SYSTEM 7000 Series Installation And Programming Instructions page 24

EMS SYSTEM 7000
15.10 Select Alarm N/O or Local N/O by
using the "" and "" buttons and
when
between the > and < arrows press
the "1" button and observe the
display changes to:
15.11 Activate the required input to be
added by applying or removing
voltage (depending upon N/O or
N/C input) and the screen will
display:
15.12 After a short period of time the
screen will change to display:
15.13 Using the same operation, once
again
after a short period of time the
screen will change to display:
15.14 You may now add additional inputs by repeating the actions detailed. If no further
inputs are to be added then escape from this menu by pressing the "3" button on
the keypad or returning the control keyswitch to the "CLEAR" position.
©2015 EMS Security Group Ltd. All rights reserved.
the required setting
generate a transmission,
Operate Transmitter
is
Escape to cancel
Reset Transmitter
Operate Transmitter
Again or press
Escape to cancel
Contact 001
Added
24
NOW or press
16:38
NOW
16:38
16:38
Push any key
16:38
TSD248 Iss 2 25/06/15 AJM