Assembly - Silvercrest SDGS 1630 A1 Operating Instructions And Safety Instructions

Assembly

1) Unscrew and remove the fixing screw
located on the appliance base
2) Hold the telescopic shaft
left side . Check if the three locking clips
unlocked (fig . B) .
3) Insert the telescopic shaft
until the holes of the telescopic shaft
same level . Reinsert the fixing screw
the telescopic shaft
each other .
4) Screw the fixing screw
so that the telescopic shaft
(fig . D) .
5) Insert the integrated clothes hanger
shaft
6) Adjust the telescopic shaft
and locking the locking clips
7) Attach the steam head
SDGS 1630 A1
q
A
C
and lock the clip on the integrated clothes hanger
q
from the telescopic shaft
e
(fig . A) .
z
so that the power cable retainer
q
on the telescopic shaft
6
into the appliance base
q
and the appliance base
q
(fig . C) . If the holes are not flush, slide
e
up or down slightly until the holes are aligned with
of the telescopic shaft
e
is firmly attached to the appliance base
q
B
D
vertically into the top of the telescopic
3
to the maximum height by pulling it upwards
q
(fig . F and G) .
6
to the steam head mount
1
, which is
q
is on the
8
are
q
and press it down
z
are at the
z
back into the shaft fully,
q
(fig . E) .
3
(fig . H) .
2
GB │ IE │ NI │ CY
z
│ 9 ■