Assembly - Silvercrest SDGS 1630 A1 Operating Instructions And Safety Instructions

Assembly

1) Unscrew and remove the fixing screw
located on the appliance base
2) Hold the telescopic shaft
left side. Check if the three locking clips
unlocked (fig. B).
3) Insert the telescopic shaft
until the holes of the telescopic shaft
same level. Reinsert the fixing screw
the telescopic shaft
each other.
4) Screw the fixing screw
so that the telescopic shaft
(fig. D).
5) Insert the integrated clothes hanger
shaft
6) Adjust the telescopic shaft
locking the locking clips
7) Attach the steam head
SDGS 1630 A1
q
A
C
q
and lock the clip on the integrated clothes hanger
e
from the telescopic shaft
z
(fig. A).
q
so that the power cable retainer
6
on the telescopic shaft
q
into the appliance base
q and the appliance base
e
(fig. C). If the holes are not flush, slide
up or down slightly until the holes are aligned with
e
of the telescopic shaft
q
is firmly attached to the appliance base
B
D
3
vertically into the top of the telescopic
q
to the desired height by pulling it upwards and
6
(fig. F and G).
1
to the steam head mount
q
, which is
8
is on the
q
are
z
and press it down
z are at the
q
back into the shaft fully,
3
(fig. E).
2
(fig. H).
GB │ IE
z
│ 33 ■