Omron H5L Series Manual page 9

H5L
First Circuit Operation Setting
To program the operation of the first circuit, "hour", "minute", and "output" must be
specified.
Press the MODE key to set the H5L in PROG 1 mode. The display will be as shown
on the left.
Since the first circuit is turned ON at 7:40, set the "hour" to 7 by pressing the + or –
key and then store it in memory by using the Write key.
Then "minute" will start blinking. Set it to 40 by using the + or – key and store it in
memory by pressing the Write key.
Now, the output status indicator will blink. Set the output to the ON status with the +
key followed by the Write key.
(If the + key is pressed twice at this time, the display will give an invalid indication
( ). Then if the Write key is pressed, this program will be deleted.)
The display returns to the initial status as shown on the left and waits for the next
program step to be input.
Since the first circuit should be turned OFF at 19:30, set the hour to 19 and the minute
to 30 by using the + or – key and then the Write key.
Now the output status indicator starts blinking. Set the output to OFF status by the –
key and store it in memory by the Write key.
The display returns to the initial status and waits for the next program step to be input.
As the first circuit operation setting is completed, let us turn to setting the "day of the
week".
H5L
9