Omron H5L Series Manual page 10

H5L
Second Circuit Operation Setting
START
START
STOP
STOP
10
Press the MODE key to set the H5L in PROG 2 mode. The display appears as shown
on the left.
In example 1, as the second circuit is to be cyclically operated, specify the cycle
program by pressing the Cycle key.
Set the start time (6:50) first. Set the hour to 6 and the minute to 50 by pressing the +
or – key. Write each set value with the Write key.
Then, set the ON time, which is 0:05 in this example.
Write the hour of 0 by pressing the Write key.
Set the minute to 5 and store it in memory by using the Write key.
Next, set the OFF time.
The OFF time is to be 0:20.
Finally, by pressing the Write key, set the hour to 0. In addition, set the minute to 20
by pressing the + or – key. Write it by pressing the Write key.
Next, set the time at which the cyclic circuit operation is to be stopped. The stop time
is to be 20:30.
Set the hour to 20 by pressing the + or – key followed by the Write key. Set the
minute to 30 by the + or – key followed by the Write key.
Now, the programming of the cyclic operation is completed.
The display is as shown on the left and waits for the next program to be input. Since
the second circuit operation in example 1 has been completed, let's move to setting
the day of the week.
H5L