Running The Program; Programming Errors - Omron H5L Series Manual

H5L
Second Circuit Day-of-the-Week Setting

Running the Program

PROGRAMMING ERRORS

1. When the OFF time is set at the same hour and minute as the ON
time, "hour" indicator blinks twice the normal rate for showing a
program error. In this case, set the OFF (or ON) time again.
2. When the ON/OFF program is superimposed on the cyclic period
(from cycle start to cycle stop), the program error is indicated as
shown below. Set the "hour" and "minute" outside the cyclic
period.
3. When a cycle program is superimposed on the existing program
(ON time, OFF time, or cycle program), the program error is
indicated as shown below. Change the start time or stop time of
the cycle program not to overlap the other existing program.
Press the MODE key to set the H5L in the DAY SET mode of the PROG 2 mode.
The display will be as shown on the left.
As the initial condition, the second circuit is to be operated on all the days of the
week, which means all the indications by the day indicators are reverse video except
that of the SUN indicator which blinks.
In example 1, the second circuit is not operated on Sunday but on all the other days;
set Sunday to be stopped accordingly using the – key and the Write key.
Then, the MON indicator starts blinking. Since on Monday through Saturday the
operation is set to be activated as the initial condition, there is no more need to set the
operation.
Now all the parameters have been programmed as in example 1. Press the MODE
key to set the H5L in the RUN mode.
The display will be as shown on the left.
The output status indicators show the current status of both outputs.
H5L
11