Torque Values - ODB SKB700 Owner's Manual

INCH BOLT AND CAP SCREW

TORQUE VALUES

TYPE
HEAD
MARK
SIZE(D)
Lub*
1/4"
7
5/16" 15
3/8" 26
7/16"
41
1/2"
63
9/16" 90
5/8" 125
3/4" 225
7/8" 360
1"
540
1-1/8"
675
1-1/4"
950
1-3/8" 1250
1-1/2" 1650
*Lub means coated with a lubricant such as engine oil, or fasteners with phospate or oil coatings. "Dry"
means plain or zinc plated without any lubrication.
DO NOT use these values if a different torque value or tightening procedure is given for a specific applica-
tion. Torque values listed are for general use only. Check tightness of fasteners periodically.
Make sure fastener threads are clean and that you properly start thread engagement. This will prevent them
from failing when tightening. Fasteners should be replaced with the same or higher grade. If higher grade
fasteners are used, these should only be tightened to the strength of the original.
Tighten plastic insert or crimped steel-type lock nuts to approximately 50 percent of the dry torque shown
inthe chart, applied to the nut, not the bolt head.
ODB COMPANY
Maintenance Section
4.5 Torque Values
SAE GRADE
5 8
LB-FT LB-FT
Dry* Lub*
9 10 12.5
18 21 26
33 36 46
52 58 75
80 90 115
115 130 160
160 175 225
280 310 400
450 500 650
675 750 975
850 1075 1350
1200 1500 1950
1550 2000 2550
2100 2650 3350
METRIC BOLT AND CAP SCREW TORQUE
8.8 or 9.8
HEAD
MARK
SIZE(D) LB-FT
Dry* Lub* Dry* Lub* Dry* Lub* Dry*
M6 6.5
M8 16
M10 32
M12 55
M14 88
M16 140
M18 195
M20 275
M22 375
M24 475
M27 700
M30 950
M33 1300 1650 1850 2350 2150 2750
M36 1650 2100 2350 3000 2750 3500
VALUES
CLASS
10.9
LB-FT
8.5 9.5 12
20 24 30
40 47 60
70 80 105
110 130 165
175 200 255
250 275 350
350 400 500
475 540 675
600 675 850
875 1000 1250 1150 1500
1200 1350 1700 1600 2000
800-446-9823
12.9
LB-FT
11.5 14.5
28 35
55 70
95 120
150 190
240 300
325 410
460 580
625 800
800 1000
54
SKB700