Rear Panel - Wohler iAM-MIX Series User Manual

Rear Panel

DC
Power
Power: The IAM-MIX uses an external AC to 18V DC power adapter. The
adapter's AC inlet is a standard IEC receptacle for 100 to 240 VAC ±10%, 50/60
Hz power connection. Four regional AC power cords, supplied per shipping
region, are available.
By design, the supplied AC mains power cord will only plug into a three-prong
grounded outlet for your safety. If the plug does not fit into the outlet, contact an
electrician to replace the obsolete outlet.
The monitor and power adapter have been tested as a combined apparatus to
verify compliance with applicable safety and electromagnetic compliance
standards. Use of another power adapter provided by the user may negate the
compliance or cause the monitor to not perform properly. Wohler Technologies
cannot accept any responsibility for the outcome in such cases.
GPIO: (future implementation) This DB-9 connector provides 2 input pins and 2
output pins to perform GPIO functions as defined by the Web GUI.
Network Port: The Ethernet port can connect to either a LAN or to a PC to let
you customize the IAM-MIX configuration. It will also allow you to copy system
configurations from one IAM-MIX to another. Lastly, it can be used to update the
IAM-MIX software and firmware.
MADI Inputs & Outputs: (1 Coax, 1 –SFP Optical) Inputs accept AES10 64-
channel MADI input signals at 48 kHz sample rate. All outputs are reclocked
from the selected MADI source. This allows coax to fiber or fiber to coax
conversion. A software license must be installed for SFP ports to function.
Dolby Metadata: This RJ-45 jack transmits metadata from the selected Dolby
bitstream in RS-485 serial data protocol.
AES Out: This BNC jack outputs the same mixed audio as the XLR analog
outputs, as heard from speakers or headphones, but as an AES3id pair.
Figure 2-2: Rear Panel Layout
MADI AES
Coax-BNC Out
GPIO
Network
Port
Dolby
Metadata
MADI
SFP-Fiber
AES In Analog In
SDI
SFP-Coax or Fiber
Page 9
Analog Audio Outputs
(Left & Right)