Table of Contents
Advertisement
CHAPTER 1: Installation
Introduction
Overview
The iAM-MIX units are 1RU multichannel multi-source audio monitors with multiple
standard copper connections and multiple SFP module options facilitating optical
fiber and high density coax connections. Refer to Specifications section or contact
Wohler sales for more information.
The iAM-MIX has individual channel volume controls and mute switches. Any
channel from any source stream may be audibly monitored and mixed with the
other selected channels. The IAM-MIX is small, low-cost, and simple to operate. Its
setup configuration can easily be copied to other IAM-MIX units.
Setups are created with a web browser over a network connection. Each iAM-MIX
can be configured with a number of presets. Nothing about the configurations of
those predefined setups can be changed from the front panel. This prevents less
experienced or hurried operators from making accidental setup changes that could
compromise their usage of the unit. It also reduces operator training to a minimum.
Safety
Instructions
1. Read, keep, and follow all of these instructions; heed all warnings.
2. Do not use this equipment near water.
3. Use only a dry cloth to clean the equipment.
4. Do not block any ventilation openings.
5. Do not install near any heat source such as a radiator, heat register, amplifier, or
stove.
6. Do not attempt to plug the unit into a two-blade outlet (with only two prongs of
equal width).
By design, this monitor will only plug into a three-prong outlet for your safety. If the
plug does not fit into the outlet, contact an electrician to replace the obsolete outlet.
7. Protect the power cord from being walked on or pinched, particularly at plug's
source on the equipment and at the socket.
8. Use only the attachments/accessories specified by the manufacturer.
Page 5
Advertisement
Table of Contents
