Table of Contents
Advertisement
Sprayer speed sensor
The speed sensor and holed disc are located in the sprayer's right side
wheel.
It works by induction and has to pass over a metal projection to trigger
a signal. A holed disc is used to do this. It has to be adjusted so that it
senses in the middle of the disc's holes (when vertical). The
recommended distance between the metal part and the sensor (A) is
between 3 and 6mm. Check that this is so over the whole circumference.
IMPORTANT! Correct operation is indicated by a constant flashing
of the sensor when you turn the holed disc.
Road signalling
Connect the plug to the 7-pin socket on the tractor and check the operation of the rear lights, stop lights, side lights and
indicators on each side before moving off.
The wiring complies with ISO 1724. See section Electrical connections page 82.
IMPORTANT! SWITCH OFF working lights when driving on public roads!
4 - Sprayer set-up
35
Advertisement
Table of Contents
