2、 Install Betaflight; 3、 Install The Receiver - GEPRC Sparrow Quick Start Manual

- Sparrow does not recommend flying in crowded places to avoid hurting people.
- if you want to feel FPV (first person vision), please flying with video glasses.
2、 Install Betaflight
Betaflight is an open source flight control procedures, specific introduction can refer to website:
-
https://github.com/betaflight
for the firmware required by Sparrow, please click the following link to download the firmware
-
name: betaflight_3.2.3_FF_PIKOBLX.hex
n Latest version of firmware download website:https://github.com/betaflight/betaflight/releases
n Be sure to download the PIKOBLX version.
Install driver and ground station Betaflight
-
n https://github.com/betaflight/betaflight/wiki/Installing-Betaflight
n Ground station Betaflight - Configurator download address (you need to install Chrome browser) :
https://chrome.google.com/webstore/detail/betaflight-configurator/kdaghagfopacdngbohiknlhcocjccjao/re
u
views
-
3、 Install the Receiver
-
If you choose the BNF version, you can Bind use the frequency and do not need to install the receiver again.
-
if you choose the PNP version, you will need to install the receiver on your own, Please click the following steps to
connect (such as the Frsky r-xsr receiver) :
n note must dismantle propeller for debugging.
n Open the screws of the Sparrow, open the top vtx board, and you can see the flight control board on the second
floor.
n The flight control board will have three welding locations: 5V,GND,S.Bus, Welding in the corresponding position
n Finally, fix the receiver and lock the corresponding screw
n As shown in the picture below:
Sparrow Manual
- 8 -
Sparrow