Output Configuration - Hantek HDG 2000 Series User Manual

3.1 Output Configuration

This section describes output channel configuration. Many commands associated with output
configuration start with SOURce1: or SOURce2: to indicate a certain channel. User can't
Output Function
The instrument includes six standard waveforms: sine, square, ramp, pulse, noise and Harmonic.
There are also nine built-in arbitrary waveforms, and you can create custom waveforms with the
embedded waveform editor.
The table below shows which functions are allowed (•) with modulation, sweep, and burst.
Selecting a function that is not allowed with a modulation or mode disables the modulation or
mode.
Carrier AM
Sine ·
Square ·
Ramp ·
Pulse
·
Gaussian ·
Noise
Arbitrary ·
Waveform
(a) Gated burst only
Frequency Limitations: Changing functions may change the frequency to meet the new
function's frequency limits.
Amplitude and offset cannot combine to exceed the instrument's capability. The one you set
last may be changed to stay within limits.
You may protect a device under test (DUT) by specifying upper and lower output voltage limits.
Front Panel
 SCPI:
SOURce<n>: FUNCtion <SINusoid|SQUare|RAMP|PULSe|NOISe|DC|SINC|EXPFall|
HAVErsine|LOREntz| DUALtone|GAUSe|ECG| USER| HARMonic| >
Output Frequency
The output frequency range depends on the function (default frequency 1 kHz for all functions).
Appendix
Please refer to
HDG2000 Series Arbitrary Waveform Generator
FM PM ASK FSK
· · · ·
· · · ·
· · · ·
· · · ·
·
B.
PSK BPSK PWM
· ·
· · ·
· · ·
· ·
Features and Function
omit.
Burst Sweep
· ·
· ·
· ·
· ·
· a
· ·
26