Prepare Instrument For Use - Hantek HDG 2000 Series User Manual

Basic Operation

1.4 Prepare Instrument for Use

This section describes basic procedures to help you get started quickly with the instrument.
Prepare Instrument for Use
Connect the power cord as desired. Turn the instrument on by pressing the power switch in the
lower left corner of front panel.
The instrument's default function is a 1 kHz, 200 mVpp sine wave. At power-on, the channel
output connectors are disabled. To enable output on a channel connector, press the key above the
channel connector and then press the Output button.
If the instrument does not turn on, verify that the power cord is firmly connected (power-line
voltage is automatically sensed at power-on). Also make sure that the instrument is connected to
an energized power source.
Power Switch:
To turn off the instrument, please press power switch.
Attention: After turning on, the process of system initialization will take 1~2 minutes; if you turn it
off before the initialization is done, the next time you turn it on, it will prompt that the system is not
properly shut-down. This is necessary to have the system restorable when it collapses, like the
"safe mode" of Windows.
First, press F1, the device will be restart.
If not, press F2 to recover the system, the system will be recovered to the factory default setting.
If not, contact the customer service to get new recover partition program, and press F3 to update
the recover partition.
HDG2000 Series Arbitrary Waveform Generator 11