Source Subsystem; Sweepsubsystem - Hantek HDG 2000 Series User Manual

SYSTem:ROSCillator:SOURce INTernal|EXTernal
SYSTem:ROSCillator:SOURce?
Parameter
INTernal|EXTernal, default INTernal
Use the external reference oscillator source: SYSTem:ROSCillator:SOURce EXTernal
 EXTernal:instrument uses signal on the rear-panel 10 MHz In connector as reference, and
generates an error if this signal is absent or the instrument cannot lock to it. In such error cases,
instrument output continues, but the frequency will be unstable.
 INTernal: instrument uses the internal reference oscillator and ignores the signal at the 10
MHz In connector.

5.2.24 SOURce Subsystem

Subsystems Using the Optional SOURce Keyword
Because SOURce subsystem commands are often used without the SOURce keyword, these
commands are listed by their individual subsystems, below:
AM
ASK
BPSK
BURSt
DATA
FM
FREQuency
FSKey
FUNCtion
MARKer
PHASe
PM
ROSCillator
SWEep
VOLTage

5.2.25 SWEepSubsystem

SOURce<n>:SWEep:HTIMe <seconds>|MINimum|MAXimum
SOURce<n>:SWEep:HTIMe? [MINimum|MAXimum]
Sets number of seconds the sweep holds (pauses) at the stop frequency before returning to the
HDG2000 Series Arbitrary Waveform Generator
Typical Return
INTernal, or EXTernal
SCPI Programming Reference
89