SloanLED HighLINER Technical Data Sheet

General Information:

HighLINER is intended for linear lighting in storerooms, walk-in coolers, so ts
and a variety of other lighting applications.
HighLINER luminaires should only be used with a SloanLED 100 Watt 24 V power supply.
FOR YOUR SAFETY
• Read and observe all NOTES, CAUTIONS and WARNINGS shown throughout these instructions.
• Installation of power supplies to be performed by licensed electrician only.
• Safety glasses or goggles should be worn while performing installation.
• This product is ETL listed for dry, damp and wet locations.
•
• Install to NEC, local and state regulations.
Tools and Accessories Recommended
Tools and connections shown are for secondary connections:
measuring tape, electrical tape, wire strippers, twist-on or push-in UL Listed wire connectors, tie-wraps, chalk line, junction-box, and
18 AWG UL Listed PLTC cable.
Items Provided
1. Power Supply 2. RDL-Linear Wire Nut Housing 3. RDL-Dimmer 4. RDL-Sensor 5. Mounting Clip
Number of luminaires required per 100 square-feet (9,29 square-meters) for open, continuously lit areas.
Ceiling Height
8 ft (2,4 m)
10 ft (3,0 m)
12 ft (3,7 m)
* Intensity measured at standard tabletop height (30 in (760 mm) from ground)
†100 lux = 9.29 foot-candela
For complete workplace lighting requirements, see OSHA requirements - Code of Federal Regulations Title 29, Section 1926.56:
Minimum Illumination Intensities * (lux) †
300 lx 400 lx
2
2
2
SIGN LIGHTING GRAPHICS DISPLAY
Excellence in Distribution Since 1946
2240 Yates Ave. Commerce, CA 90040 | Fax 323.803.2019 | 800.CALL IEC
(optional)
500 lx
3 3
3 3
3 4
www.IECDelivers.com
TECHNICAL DATA SHEET
HighLINER
LED Linear Lighting System
Installation Manual
SLO-HL-OLL
6. RDL-Linear Light
(optional)
600 lx
4
4
4
(225.5432)
Page 1 of 4
drill,