Summary of Contents for PCE Health and Fitness SM 11
Page 1
Fax: (0) 2380 98703 9 Pen type, all in one, info@pce-americas.com info@pce-instruments.com SALT METER www.pce-instruments.com/english www.pce-instruments.com Model : PCE-SM 11 Your purchase of this SALT METER marks step forward for you into the f i e l d p r e c i s i o n measurement.
1. FEATURES * The pen type, all in one Salt meter provides fast, accurate readings, with digital readability and easy operation. * Measuring range : 0 to 12 % salt ( % weight ). * Build in temperature sensor, ATC ( auto temperature compensation ).
Page 4
DC 1.5V battery ( UM-4/AAA ) x 4 PCs. Power Approx. 5.7 mA. Consumption Dimension 190 x 40 x 40 mm ( 7.5 x 1.6 x 1.6 inch ). Weight 171 g/0.38 LB. Standard Instruction Manual......1 PC Accessories PCE-SM 11...
3. FRONT PANEL DESCRIPTION 3-1 Battery compartment/Cover 3-2 Display 3-3 Power Button 3-4 Hold Button 3-5 REC Button 3-6 Salt Sensing Head 3-7 Protection Cover for Sensing Head...
4. MEASURING PROCEDURE 4-1 Salt measurement 1) Turn on the meter by pressing the " Power Button " ( 3-3, Fig. 1 ) momentarily. * Press the " Power Button " ( 3-3, Fig. 1 ) momentarily again will turn off the meter. The "...
Fig. 2 When make the measurement should immerse the " Sensing Head " immersed wholly into the measured solution. 3)The " Sensing Head " build in the temperature sensor for the usage of automatic Temp. compensation. If the temperature of measured salt solution is changed, then it should take few minutes to let the display reading reach the stable value.
b)Press the " REC Button " ( 3-5, Fig. 1 ) momentarily again, the " REC MIN " symbol along with the minimum value will appear on the display. * When display shows " REC MAX " or " REC MIN ", press the "...
flash 4) Use the " Up button " , " Down button " to select the desired calibration value, then wait about 5 second, the calibration data will saved into the memory circuit, and finish the calibration procedures. Note : During execute the calibration procedures and before not finish the complete calibration procedures, if intend to exit the calibration procedure, then just press the "...