SCML1+1SL ( /V1, /V2 , /V3 & /V4 )
4.2 Frontal Panel Description
[1] SYNOPTIC
[2] MANUAL
[3] LOCAL
[4] MAINS
[5] ALARM
[6] DISPLAY
[7] CONTRAST
[8] ENCODER
[9] SERVICE
[10] POWER
4
/ 30
1
2
3 4 5
6
Figure 4.1
Series of LED for the instantaneous vision of the exchange condition.
Shows the position of coaxial relay, the state of dummy load and of
transmitter connects to it.
Yellow LED, lit when the change-over is set up in order to allow the control
exclusively from the customer, inhibiting the automatic management of the
equipment functionalities.
Yellow LED, lit when the change-over is set up in order to receive controls
exclusively from the encoder, inhibiting any source of telecontrol.
Yellow LED, lit when the change-over is supplied at 24V.
Red LED, lit when the change-over has had problems during the phase of
exchange between the two transmitters.
Liquid crystals display (2 rows, 16 characters).
Display contrast adjusting trimmer.
Knob and button in order to software control.
DB9 connector for factory parameters programming.
Mains switch.
Rev. 2.0 - 17/02/17
7
8
9
ELETTRONICA
10
User Manual