Table of Contents
Advertisement
SCML1+1SL ( /V1, /V2 , /V3 & /V4 )
ELETTRONICA
5. Quick guide for installation and use
This section provides a step-by-step description of equipment installation and
configuration procedure. Follow these procedures closely upon first power-on
and each time any change is made to general configuration, such as when a new
transmission station is added or the equipment is replaced.
Once the desired configuration has been set up, no more settings are required
for normal operation; at each power-up (even after an accidental shutdown),
the equipment defaults to the parameters set during the initial configuration
procedure.
The topics covered in this section are discussed at greater length in the next
sections, with detailed descriptions of all hardware and firmware features and
capabilities. Please see the relevant sections for additional details.
IMPORTANT: When configuring and testing the transmitter in which the equipment
is integrated, be sure to have the Final Test Table supplied with the equipment ready
at hand throughout the whole procedure; the Final Test Table lists all operating
parameters as set and tested at the factory.
5.1 User Interface
The machine features an LCD with two lines by 16 characters that displays a set
of menus.
The status of the machine is indicated by four LEDs located on the front panel:
MANUAL, LOCAL, MAINS, ALARM and seven LED for synoptical signalling.
The interaction between the user and the exciter control software is performed
using the encoder.
The operations that you can perform on the encoder are: :
12
User Manual
/ 30
Rev. 2.0 - 17/02/17
Advertisement
Table of Contents
