Convert an MO Jukebox to UDO or Mixed-Media Technology
Remove existing drives
To remove existing drives:
1. Disconnect cables that connect the drives to the interposer board at the interposer board
2. For each drive module, remove the 2 T-20 torx screws from each side of the drive module
3. Carefully slide the drive module back and out of the chassis.
Note:
converting to UDO only, discard or recycle these drives.
18
Caution:
Parts can be damaged by electrostatic discharge. Keep parts in their containers
until needed. Ensure you are properly grounded when touching static-sensitive components.
end.
(4 screws total).
If you are converting to mixed-media, set aside the drive modules for later use. If you are
3800ux/7100ux Optical Jukebox Conversion Guide