Attaching The Mounting Brackets; Attaching The Static-Rails Mounting Brackets; Installing The Dell Static Rails System; Identifying The Rail Kit Contentsinstalling And Removing Tool-Less Rails (Square-Hole)Installing And Removing Tooled Rails (Threaded-Hole Racks Or Round-Hole Racks) - Dell Z9500 Installation Manual

Attaching the Mounting Brackets

The switch is shipped with static rails mounting brackets (rack ears) and the required screws for rack or
cabinet installation. The brackets are enclosed in a package with the chassis.

Attaching the Static-Rails Mounting Brackets

1. Take the static-rail mounting brackets and screws out of their packaging.
2. Attach the brackets to the I/O side of the chassis, using eight screws for each bracket.
Attach the bracket so that the "ear" faces to the I/O side and the outside of the chassis.
1. Utility side of the chassis
3. Static-rail mounting bracket

Installing the Dell Static Rails System

Dell Networking provides the Static Rails rack mounting system so you can easily configure a rack to
install the switch.
Identifying the Rail Kit Contents
Locate the components for installing the rail kit assembly:
• Two Dell Static Rails assemblies (1) (2).
NOTE: Supports rack length between 24 and 36 inches.
20
2. Screws
Z9500 Installation