Certificates And Approvals; Ce Mark, Declaration Of Conformity; Ex Approval; Type Of Protection - Endress+Hauser Soliphant T FTM20 Technical Information

CE mark,
declaration of conformity

Ex approval

Type of protection

Other standards and
guidelines
Pressure Equipment Directive
2014/68/EU (PED)

RCM-tick mark

EAC conformity

RoHS

12

Certificates and approvals

The measuring system meets the legal requirements of the applicable EC Directives. These are listed in
the corresponding EC Declaration of Conformity along with the standards applied.
Endress+Hauser confirms successful testing of the device by affixing to it the CE mark.
Your Endress+Hauser sales centre can provide you with information on the Ex versions which can currently
be delivered.
All explosion protection data are given in a separate documentation (see "Supplementary Documentation")
which is available upon request.
Copies of certificates available upon request.
See "Ordering information" as of Page 13 and "Supplementary documentation" on Page 15.
Other standards and guidelines that were taken into consideration in designing and developing Soliphant T
FTM20, FTM21:
• Low Voltage Directive (73/23/EEC)
• DIN EN 61010 Part 1, 2001
Protection Measures for Electrical Equipment for Measurement, Control, Regulation and Laboratory
Procedures
Part 1: General requirements
• EN 61326
Electrical Equipment for Measurement, Control and Laboratory Use
EMC requirements
Pressure instruments with permitted pressure ≤ 200 bar (2 900 psi)
Pressure instruments with permitted pressure ≤ 200 bar (2 900 psi) Pressure instruments with a
flange and threaded boss that do not have a pressure-bearing housing do not fall within the scope of
the Pressure Equipment Directive, irrespective of the maximum permitted pressure.
Reason:
According to Article 2, point 5 of EU Directive 2014/68/EU, pressure accessories are defined as
"devices with an operational function and having pressure-bearing housings".
If a pressure instrument does not have a pressure-bearing housing (no identifiable pressure chamber
of its own), there is no pressure accessory present within the meaning of the Directive.
Note:
A separate analysis must be performed for pressure instruments that are part of safety equipment
designed to protect a pipe or vessel from exceeding allowable limits (safety accessory in accordance
with Pressure Equipment Directive 2014/68/EU, Article 2, point 4).
The product or measuring system supplied complies with the regulations of the Australian
Communications and Media Authority (ACMA) for network integrity, performance characteristics and
health and safety requirements. The specifications for electromagnetic compatibility, in particular, are
observed. The products bear the RCM-tick mark on their nameplate.
The measuring system meets the legal requirements of the applicable EAC Directives.
These are listed in the corresponding EAC Declaration of Conformity along with the standards applied.
Endress+Hauser confirms successful testing of the device by affixing to it the EAC mark.
The measuring system complies with the substance restrictions of the EU Directive on the restriction
of the use of certain hazardous substances 2011/65/EU (RoHS 2).
Soliphant T FTM20, FTM21
A0029561
Endress+Hauser