Command # 43: Factory Parameters Reset; Remote Programming - EmerCom Technologies EMC-60 User Manual

Command # 43: FACTORY PARAMETERS RESET

5.2.34
All parameters are reset to factory default, including clearing the "Location
Announcement". Enter <1> to confirm.
Voice Prompt: "Factory parameters reset"

5.3 Remote Programming

Calling into EC-Phones
For low-rise applications (without a consolidator), each elevator phone must be programmed
with its own unique station number (Command #5).
If Auto Answer is set to "1" in all EC-Phones connected to the phone line (Command #14), all
the phones will answer incoming calls after the first ring. Station #1 will play a voice prompt,
directing the caller to enter the desired station number followed by the <*> key. Pressing <1><*>
will connect to the EC-Phone with Station # = 1 and all phones with Station # ≠ 1 will hang-up.
Press <2><*> to connect to the phone with Station # = 2, etc. Two way communications is not
established until the Station Number is selected.
If a Consolidator or Rescue Station is in circuit, the Station Number is determined by the
Consolidator or Rescue Station and the Station Number programmed into the phone has no
effect.
To program remotely:
1. Call the telephone line to which the required EC-Phone is connected. Follow the voice
prompt to select the required phone.
2. Enter 99* to enter programming mode. The phone will request the "access code"
(Factory default is 12345) to which the phone will respond with "program" followed by a
confirmation beep.
The same functions are available in remote programming as in programming locally on
the EC-Phone keypad with the following codes for keypad functions:
Keypad
PROGRAM
CANCEL
ENTER
REPLAY
EXIT
3. If the access code is incorrect, the prompt "incorrect entry, please re-enter" will play.
4. To remotely program another cab, hang up and call again, selecting the new cab
number.
Equivalent Remote Sequence
99* + "Access Code"
*1
**
#
*9
EMC-60 User Guide
- 22 -