Command # 8: Alarm Status Playback; Command # 9: Access Code; Command # 10: Language; Command # 11: Primary Ring Transfer Count - EmerCom Technologies EMC-60 User Manual

Command # 8: ALARM STATUS PLAYBACK

5.2.8
The <ALARM STATUS> touch key duplicates the "Alarm Status" command.
Voice Prompt: "Alarm status"
Note: The battery is a rechargeable NiMH battery and should have a full charge within 1
day of the EC-Phone being connected to AC power. Replace the battery if the alarm
status indicates a dead battery, although, even if the battery indicates a full charge, it
should be replaced every 5 years.

Command # 9: ACCESS CODE

5.2.9
Entry of a 5 digit access code will be required for remote programming. Changing the
access code to a unique number will prevent others calling in and modifying the
settings. Default 12345.
Caution: Programming by calling in remotely will not be possible without the access
code.
Voice Prompt: "Access code"

Command # 10: LANGUAGE

5.2.10
The EC-Phone has built-in voice prompts to assist both the passengers and emergency
centre operator when an emergency call is in progress and to simplify programming. If
the EC-Phone is set to either English (0) or French (1), voice prompts heard by the
passenger, monitoring station and programmer will be played in the language chosen.
The programmer can choose their language preference. With the English / Spanish
setting (4), all operating status information heard by passengers will be played in
English followed by Spanish, while the response for programmers and monitoring
personnel are in English.
Voice Prompt: "Language"

Command # 11: PRIMARY RING TRANSFER COUNT

5.2.11
After dialing the "Primary Phone Number", the "Primary Ring Transfer Count" is the
number of rings the EC-Phone counts before concluding that there has been 'no
answer'. After the last ring, the phone hangs up and either calls the "Secondary Phone
Number" if it has been programmed or calls the "Primary Phone Number" again until the
end of 3 cycles after which it will return to idle mode and the PHONE button will have to
be pressed again to resume the cycle.
Voice Prompt: "Primary ring transfer count"
EMC-60 User Guide
- 16 -