Command # 32: Push & Hold; Command # 33: Service Prompt; Command # 34: Voice Detection Threshold; Command # 35: Phone Line Type - EmerCom Technologies EMC-60 User Manual

Command # 32: PUSH & HOLD
5.2.25
This sets how long the button has to be pressed to trigger an emergency call.
0 = Instant (single press), 1 = Push and Hold enabled; hold call button for 1 second or
more or press 3 times in the space of 5 seconds.
Voice Prompt: "Push and Hold"

Command # 33: SERVICE PROMPT

5.2.26
If Service Prompt = 1 and the last emergency call was not answered, the service prompt
is played on the speaker at the end of the call and every 5 minutes thereafter. The
service prompt stops playing after a successful call or when the Service Prompt = 0.
Voice Prompt: "Service Prompt"

Command # 34: VOICE DETECTION THRESHOLD

5.2.27
If the voice in the cab is too quiet for the operator, increase the Microphone Sensitivity
(#31) as required. If "chopping" occurs, increase the Threshold (default = 3).
Voice Prompt: "beep"

Command # 35: PHONE LINE TYPE

5.2.28
Set Phone Line Type to 0 if phone line is soft/quiet or to 2 if noise (static, interference,
buzz or hum) is present.
Voice Prompt: "beep"
Sample settings for different line types
Phone line
characteristics
Quiet (magicJack)
Standard
Intermittent noise or
interference
Call from machine room
with loud fan
Speaker Microphone
#30 #31
6 5
5 5
5 5
5 7
EMC-60 User Guide
Threshold Line type
#34 #35
0 0
3 1
5 2
7 2
- 20 -