Memory Operation On "Home" Channel Memories; Home Channel Storage; Home Channel Recall - Yaesu FT-818ND Operating Manual

Memory Operation on "HOME" Channel Memories

Four Special one-touch "Home" channels are available, for special frequencies you use
often. Either "simplex" or "split" frequency/mode data may be stored in the "Home" channel
locations. Special "Home" channels are available for HF (any frequency between 1.8 and
29.7 MHz), 50 MHz, 144 MHz, and 430 MHz.
These memories may prove particularly useful for monitoring propagation beacons, pro-
viding one-touch recall of the beacon frequency for a quick check of band conditions.

HOME Channel Storage

1. Tune the desired frequency, and set the operating mode. If this is an FM channel, set
up any required CTCSS/DCS and repeater shift configurations.
2. Press the key momentarily, then rotate the
Function Row 2 [ MW, MC, TAG ] appears on the display.
( MW ) key momentarily to enter the "Memory Check" mode.
3. Press the
4. Press and hold in the
"Home" channel location. As usual, you will hear a double beep to confirm the success-
ful storage of the frequency data.
5. If you wish to store a "Split" frequency pair into the "Home" channel, store the Receive
frequency in steps 1 ~ 4 above. Now set the desired Transmit frequency.
6. Once more, press the
7. Press and hold in the microphone's PTT switch; while holding the PTT switch, again
press and hold the
into the "Home" channel location.

HOME Channel Recall

1. Press the key momentarily to recall the Home Channel on the band group where
you currently are operating (HF, 50 MHz, 144 MHz, or 430 MHz). The "HOME" indica-
tion will appear on the display.
2. Press the key once more to return to the previously-used frequency (either a VFO
frequency or a memory channel).
key for one second. This stores the frequency data into the
( MW ) key momentarily.
key for one second. This stores the transmit frequency data
Memory Operation
knob, as needed, until Operating
43