Changing The Frequency Step; Selecting The Communication Mode - Yaesu FT3DR Operating Manual

Changing the Frequency Step

The DIAL knob rotation frequency step may be changed. Normally, the factory default
setting will provide a good frequency step.
1. Press and hold the [DISP] key, then touch [CONFIG].
2. Touch [18 STEP] then rotate the DIAL knob to change the frequency step.
3. Press the PTT switch to save the setting and return to normal operation.
In the default setting, of the frequency step is set to "AUTO", which automatically provides
a suitable frequency step according to the frequency band.

Selecting the Communication Mode

z Using AMS
The FT3DR/DE transceiver is equipped with the AMS
(Automatic Mode Select) function which automatically
selects the communication mode corresponding to the
received signal.
To utilize the AMS function, touch [MODE] repeatedly
to display " *", "
receiving the signal, "FM" of "
the mode of the received signal.
*The display differs depending on the received signal.
z Setting the transmit mode when using the AMS
function
The AMS function will automatically set the receiver to
the mode of the received signal, but the transmit mode
may be fixed regardless of the received mode.
1. Touch [AUTO]* to tune to the desired transmit mode
as follows.
*The display differs depending on the transmit mode.
Transmit Mode
AUTO
(default)
TX FM
TX DN
(TX DIGITAL)
*" or " *" on the display. After
" will change to indicate
Receive‫ ׃‬Automatically selects the receive mode corresponding to the received sig-
nal.
Transmit: Automatically transmits in the communication mode selected by the AMS
function.
Receive‫ ׃‬Automatically selects the receive mode corresponding to the received sig-
nal.
Always transmits in the analog FM mode.
Transmit:
Receive‫ ׃‬Automatically selects the receive mode corresponding to the received sig-
nal.
Transmit‫ ׃‬Always transmits in the DN mode.
Receive and Transmit
25