Setting The Beep Volume; Turning Off The Busy Indicator; Setting The Clock Shift For The Micro Computer Clock Type Function - Yaesu FT3DR Operating Manual

OFF No confirmation sound is emitted when a band edge/CH1 is encoun-
tered.
ON Emits the confirmation sound when a band edge/CH1 is encountered.
Remark The default setting: OFF

4 Setting the BEEP volume

Set the volume of the beep sound.
1. Press and hold the [DISP] key, and then touch [CONFIG].
2. Touch [4 BEEP LEVEL].
3. Rotate the DIAL knob to select the desired setting.
HIGH Volume level set to HIGH
LOW Volume level set to LOW
Remark The default setting: HIGH

5 Turning off the BUSY Indicator

When listening to the radio continuously or to extend the remaining battery operating
time, turn off the BUSY indicator to save battery power consumption.
1. Press and hold the [DISP] key, and then touch [CONFIG].
2. Touch [5 BUSY LED].
3. Rotate the DIAL knob to select "A BAND", "B BAND" or "RADIO", then press the
[DISP] key.
4. Rotate the DIAL knob to select the desired setting.
ON Turns the BUSY indicator ON.
OFF Turns the BUSY indicator OFF.
Remark The default setting: ON
5. Press the [BACK] key.
6. To change the setting for other bands, repeat steps 3 to 5.

6 Setting the Clock Shift for the Micro Computer Clock Type Function

Set the micro computer Clock Shift function may be activated to eliminate an internally
generated spurious high frequency signal. Select [A] for normal use.
1. Press and hold the [DISP] key, and then touch [CONFIG].
2. Touch [6 CLOCK TYPE].
3. Rotate the DIAL knob to select the desired setting.
A Automatically switches the Clock Shift function between ON & OFF.
B Activates the Clock Shift function constantly.
Remark The default setting: A
78