Possible Failures And Solutions - K&S BASIC KSB 6000D Owner's Manual

POSSIBLE FAILURES AND SOLUTIONS

Typical failures
Engine starting swich set
Engine does not
start
Low-quality or dirty fuel is in
Low engine power /
heavy starting
Engine is overheated
No voltage while
engine is working
Connected devices
Short circuit occurred in one
are not working
of the devices connected
while generator is
running
Repetitions of an engine are
Possible reason
Set the engine starting
to OFF position
No fuel
engine
Dirt in fuel tank
Air filter is dirty
Water or air in the fuel line
Cooling fins are dirty
Air filter is dirty
Circuit breaker is active Turn on the circuit breaker
Connected cables are
if using extension cord,
corrupted
Plugged device failure Try to connect other devices
Unplug some devices to
Generator is overloaded
Unplug that device to restore
the stability of a system
Air filter is dirty
Contact the service center
lower than nominal
18
Solution
switch to ON
Add fuel
Change the fuel
Clean the fuel tank
Clean the air filter
Pump the fuel line
Clean the cooling fins
Clean the air filter
Check the cables;
change it
reduce load
Clean the air filter